|
Power Station V1
All parts of the picture
All weight: 98g
TECHNICAL SPECIFICATIONS
- 8 Inputs 16 outputs (A,B,C,D,E,F,G,H)
- 16 Buffered/Filtered and amplified outputs. (A,BB,CC,DDD,EEE,FF,GG,H)
- Both power and servo signal are amplified - Can drive up to 10 metres servo wire per channel!
- Servo power output equals power input (input 7.4volts, and servos receive 7.4 volts)
- 5.2 Volt 2.0 Amp Regulated output for receiver on all channels for improved redundancy
- Dual Battery Inputs - Auto Load sharing and failsafe switch over "PowerMatch" LEDs show which battery is being used, or when both are equal
- Includes rubber grommets and aluminium standoffs and screws
- 70 Amp power bus (35 Amp per input)
- XT60 Input Connections
- 6 volt Minimum input is required (pref regulated) - 10 Volt Max Input
- Designed for 2 cell Li-Po/Li-Ion
- Cannot be used with 4 cell (4.8v) NiCad/NiMH requires 6 volt input minimum at all times>/li>
- Includes 8 leads for connection to receiver, additional leads can be purchased seperately
- Works with PPM, PCM, 2.4Ghz systems
- Low Voltage Setting
特價:4950元 |
上一篇:【童愛模型】韓國SECRAFT模型精品配件~TOC輪軸~下一篇:【童愛模型】韓國SECRAFT模型精品配件~TOC 40%尾輪組
|